Alternatives to the OSPF Network Command
As of Cisco IOS Software Release 12.3(11)T, OSPF configuration can completely omit the network command, instead relying on the ip ospf process-id area area-id interface subcommand. This new command enables OSPF on the interface and selects the area. For instance, on R3 in Example 10-8, the network 10.3.0.0 0.0.255.255 area 3 command could have been deleted and replaced with the ip ospf 1 area 3 command under S0/0.1 and e0/0. The network and ip ospf area commands have some mi..
Orthogonal Frequency Division Multiplexing
OFDM is not a form of spread spectrum. Instead, OFDM divides a data signal across 48 separate subcarriers within a 20-MHz channel to provide transmissions of 6, 9, 12, 18, 24, 36, 48, or 54 Mbps. Data rates of 6 Mbps, 12 Mbps, and 24 Mbps are mandatory for all 802.11-compliant products. OFDM is extremely efficient, which enables it to provide the higher data rates. In addition, OFDM is highly immune to multipath propagation problems that cause significant performance issues w..
Calculating Classfully Assumed Network Ranges
A common task in addressing is to take an IP address and to understand the range of addresses that are on the same network. Originally, this was done by reading the first bits of the address to determine a class; this is called classful addressing. The portion of the address consumed by the network prefix was then assumed, based on that class. Table 2-2 shows the first bits of an IP address, the corresponding classes, and the number of bytes assumed to be in the network..
One of the key themes that is developed throughout this chapter is the idea that routing is critical to scalable network design. Hopefully, this is not news to you. However, given the recent popularity and focus on extremely flat, "avoid-the-router" designs, a fair amount of attention is devoted to this subject. Many people are convinced that the key objective in campus network design is to eliminate as many routers as possible. On the contrary, my experience suggests that th..
High CPU Utilization Level Troubleshooting
The load on a switch’s CPU is often low, even under high utilization, thanks to the TCAM. Because the TCAM maintains a switch’s forwarding logic, the CPU is rarely tasked to forward traffic. The show processes cpu command that you earlier learned for use on a router can also be used on a Cisco Catalyst switch to display CPU utilization levels, as demonstrated in Example 5-19. Notice in the output in Example 5-19 that the switch is reporting a 19 percent CPU load, with ..
